TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 643 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1465 2-1465 2-1465 2-1465 2-1465 CONTINUITY TEST Underlift fold up Stinger in Underlift up Main winch RH in Main winch RH out Main winch speed RH high Main winch LH out Main winch speed LH high Underlift down Stinger out Underlift fold down Emergency stop Function Main winch LH in UP IN UP IN IN OUT HIGH OUT HIGH DOWN OUT DOWN KILL Remote Control Box Position and Switch Number Switch Pin Positive (+) 9 7 7 7 7 7 7 7 7 7 7 7 7 Switch Pin Negative (-) 2 3 4 6 8 11 12 13 14 16 15 17 10 REF DES S15 S15 S14 S13 S10 S8 S8 S9 S10 S11 S13 S14 S7 TABLE 2-16. REMOTE CONTROL BOX SWITCH CONTINUITY TEST (1) Open cover on remote control box. (2) Remove four screws, washers, and panel from remote control box. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to pin listed in Table 2-16. Remote Control Box Switch Continuity Test. (5) Connect negative (-) probe of multimeter to pin listed in Table 2-16. Remote Control Box Switch Continuity Test. (6) Position remote control box switch to position listed in Table 2-16. Remote Control Box Switch Continuity Test and note reading on multimeter. (7) If continuity is not present, repair wire (para 2-45) or replace remote control box switch (para 7-35). (8) Install panel on remote control box with four washers and screws.