TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 641 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1463 2-1463 2-1463 2-1463 2-1463 CONTINUITY TEST Underlift fold up Stinger in Underlift up Main winch LH in Main winch RH in Main winch RH out Main winch speed RH high Main winch LH out Main winch speed LH high Underlift down Stinger out Underlift fold down Emergency stop UP IN UP IN IN OUT HIGH OUT HIGH DOWN OUT DOWN KILL Function Remote Control Box Position P2 Pin Positive (+) c c c c c c c c c c c c a P2 Pin Negative (-) e f g d b Y X W V U T S Z TABLE 2-15. REMOTE CONTROL BOX CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to pin listed in Table 2-15. Remote Control Box Continuity Test. (3) Connect negative (-) probe of multimeter to pin listed in Table 2-15. Remote Control Box Continuity Test. (4) Position remote control box switch to position listed in Table 2-15. Remote Control Box Continuity Test and note reading on multimeter. (5) If continuity is not present, go to step 4 of this fault. (6) If continuity is present, repair wire (para 2-45) or replace M1089 remote control wiring harness (para 7-117).