TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 637 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1459 2-1459 2-1459 2-1459 2-1459 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. VOLTAGE TEST Remote Control Box Switch Position 2 3 4 6 8 Underlift fold up Stinger in Underlift up Main winch LH in Main winch RH in Main winch RH out 17 16 15 13 11 12 Main winch speed RH high Main winch LH out 14 Main winch speed LH high Underlift down Stinger out Underlift fold down TB No. ACTUATOR NAME UP IN UP IN IN OUT HIGH OUT HIGH DOWN OUT DOWN TABLE 2-13. ACTUATOR VOLTAGE TEST (1) Connect wrecker remote control cable to RH remote control bulkhead connector (TM 9-2320-366-10-1). (2) Set multimeter to vdc. (3) Connect positive (+) probe of multimeter to terminal listed in Table 2-13. Actuator Voltage Test. (4) Connect negative (-) probe of multimeter on ground. (5) Position master power switch to on (TM 9-2320-366-10-1). (6) Position remote control box switch to position listed in Table 2-13. Actuator Voltage Test and note reading on multimeter. (7) If 24 vdc is not present, go to step 3 of this fault. (8) Position master power switch to off (TM 9-2320-366-10-1). (9) Disconnect remote control cable from RH remote control bulkhead connector (TM 9-2320-366-10-1).