TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 617 of 1632
TM 9-2320-366-20-2 Change 1 2-1456.5 WARNING Goggles must be worn while operating wrecker control panel. Blowing dust and debris may become airborne while engine is running. Failure to comply may result in injury to personnel. Wear leather gloves at all times when handling winch cable. Do not allow cable to slide through hands even with gloves on. Broken wires may cause injury. Never let moving cable slide through hands, even when wearing gloves. A broken wire could cut through gloves and cut hands. Failure to comply may result in injury to personnel. OPERATIONAL TEST (1) Position MAIN WINCH LH FREESPOOL switch to OFF. (2) Position MAIN WINCH RH FREESPOOL switch to ON. (3) Pull cable to see if RH 30K winch drum free spools. (4) If RH 30K winch does not freespool, go to step 9 of this fault. (5) Position MAIN WINCH RH FREESPOOL switch to OFF. (6) Set engine speed to idle (750 rpm) by decreasing HAND THROTTLE lever to full down position. (7) Position PTO switch to off. (8) Shut down engine (TM 9-2320-366-10-1).