TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 605 of 1632
Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION NOTE CONTINUITY TEST Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. TM 9-2320-366-20-2 Change 1 2-1450.27 (1) Install circuit breaker CB50 in PDP. (2) Disconnect connector P107 from connector J107. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to connector P108 socket 16. (5) Connect negative (-) probe of multimeter to connector P107 socket g and note reading on multimeter. (6) If continuity is not present, repair wire 2006 from connector P107 socket g to connector P108 socket 16 (para 2-45) or replace M1089 rear lights cable assembly (para 7-104). (7) If continuity is present, repair wire 9 from connector J107 to terminal block TB9 (para 2-45) or replace M1089 control panel power cable assembly (para 7-109). (8) Connect connector P108 to connector J108. (9) Install kick panel (para 16-3). (10) Connect connector P107 to connector J107. (11) Install wrecker control panel top cover (para 14-4). (12) Connect batteries (para 7-57).