TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 559 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1435 2-1435 2-1435 2-1435 2-1435 CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector J4-a. (3) Connect negative (-) probe of multimeter to wrecker control panel terminal board position C and note reading on multimeter. (4) Connect positive (+) probe of multimeter to connector J4-b. (5) Connect negative (-) probe of multimeter to wrecker control panel terminal board position C and note reading on multimeter. (6) If continuity is not present at connector J4-a and/or J4-b, repair wire 9 (para 2-45) or replace wrecker control panel wiring harness (para 7-83). (7) If continuity is present, repair wire 3087 (para 2-45) or replace rear lights cable assembly (para 7-104). (8) Connect connector P107 to connector J4. (9) Install top control panel cover (para 17-20).