TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 555 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1431 2-1431 2-1431 2-1431 2-1431 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. VOLTAGE TEST (1) Disconnect connector P108 from connector J108. (2) Set multimeter to volts dc. (3) Connect positive (+) probe of multimeter to connector P108-18. (4) Connect negative (-) probe of multimeter to ground. (5) Position master power switch to on (TM 9-2320-366-10-1) and note reading on multimeter. (6) If 24 vdc is not present, repair wire 2006 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (7) If 24 vdc is present, repair wire 2006 (para 2-45) or replace rear lights cable assembly (para 7-104). (8) Position master power switch to off (TM 9-2320-366-10-1). (9) Connect connector P108 to connector J108. (10) Install personnel heater (para 18-9). (11) Install top control panel cover (para 17-20).