TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 543 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1419 2-1419 2-1419 2-1419 2-1419 CONTINUITY TEST CONTINUITY TEST (1) Loosen four screws on junction box. (2) Open cover on junction box. (3) Disconnect overload lockout cable connector from overload shutdown box. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter in socket A of overload lockout cable connector. (6) Connect negative (-) probe of multimeter to terminal board position 1 and note reading on multimeter. (7) If continuity is not present, replace overload lockout cable (para 7-116). (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter in socket B of overload lockout cable connector. (3) Connect negative (-) probe of multimeter on terminal board position 19 and note reading on multimeter. (4) If continuity is not present, replace overload lockout cable (para 7-116). (5) If continuity is present, perform Electrical System Troubleshooting (e130. M1089 Hoist Up Lockout Does Not Activate, e131. M1089 Boom Down Lockout Does Not Activate, e132. M1089 Boom Up Lockout Does Not Activate, and e133. M1089 Telescope Out Lockout Does Not Activate). (6) Connect overload lockout cable connector to overload shutdown box. (7) Close cover on junction box. (8) Tighten four screws on junction box. (9) Connect batteries (para 7-57).