TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 527 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1403 2-1403 2-1403 2-1403 2-1403 CONTINUITY TEST CONTINUITY TEST (1) Loosen four screws on junction box. (2) Open cover on junction box. (3) Disconnect hoist up lockout solenoid cable connector from hoist up lockout solenoid. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter in socket 1 of hoist up lockout solenoid cable. (6) Connect negative (-) probe of multimeter to terminal board position 19 and note reading on multimeter. (7) If continuity is not present, replace hoist up lockout solenoid cable (para 7-112). (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter in socket 2 of hoist up lockout solenoid cable connector. (3) Connect negative (-) probe of multimeter on ground in junction box and note reading on multimeter. (4) If continuity is not present, replace hoist up lockout solenoid cable (para 7-112). (5) Connect hoist up lockout solenoid cable connector to hoist up lockout solenoid valve. (6) Close cover on junction box. (7) Tighten four screws on junction box cover.