TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 503 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1379 2-1379 2-1379 2-1379 2-1379 OUTPUT VOLTAGE TEST (9) Position SWING CW/CCW controller to CW and note reading on multimeter. (10) If 24 volts dc is not present, go to step 3 of this fault. NOTE Step (9) requires the aid of an assistant. Remove rings, bracelets, watches, necklaces, and any other jewelry beffore working around vehicle. Jewelery can catch on equipment and cause injury or short circuit across electrical circuits and cause severe burns or electrical shock. WARNING (1) Connect external remote control cable to remote control box (TM 9-2320-366-10-1). (2) Loosen four screws on junction box. (3) Open cover on junction box. (4) Position MAIN POWER switch to ON. (5) Lift guard and position remote control box ON/OFF switch to ON. (6) Set multimeter to volts dc. (7) Connect positive (+) probe of multimeter on terminal board lower position 10. (8) Connect negative (-) probe of multimeter on ground quick-connect terminal board (above MAIN POWER switch).