TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 491 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1367 2-1367 2-1367 2-1367 2-1367 OUTPUT VOLTAGE TEST (9) Position TELESCOPE IN/OUT controller to OUT and note reading on multimeter. (10) If 24 volts dc is not present, go to step 3 of this fault. NOTE Step (9) requires the aid of an assistant. Remove rings, bracelets, watches, necklaces, and any other jewelry beffore working around vehicle. Jewelery can catch on equipment and cause injury or short circuit across electrical circuits and cause severe burns or electrical shock. WARNING (1) Connect external remote control cable to remote control box (TM 9-2320-366-10-1). (2) Loosen four screws on junction box. (3) Open cover on junction box. (4) Position MAIN POWER switch to ON. (5) Lift guard and position remote control box ON/OFF switch to ON. (6) Set multimeter to volts dc. (7) Connect positive (+) probe of multimeter on terminal board lower position 11. (8) Connect negative (-) probe of multimeter on ground quick-connect terminal board (above MAIN POWER switch).