TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 443 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1319 2-1319 2-1319 2-1319 2-1319 OUTPUT VOLTAGE TEST (9) Position HOIST UP/DOWN controller to DOWN and note reading on multimeter. (10) If 24 volts dc is not present, go to step 3 of this fault. (11) Position MAIN POWER switch to OFF. NOTE Step (9) requires the aid of an assistant. Remove rings, bracelets, watches, necklaces, and any other jewelry beffore working around vehicle. Jewelery can catch on equipment and cause injury or short circuit across electrical circuits and cause severe burns or electrical shock. WARNING (1) Connect external remote control cable to and remote control box (TM 9-2320-366-10-1). (2) Loosen four screws on junction box. (3) Open cover on junction box. (4) Position MAIN POWER switch to ON. (5) Lift guard and position remote control box ON/OFF switch to ON. (6) Set multimeter to volts dc. (7) Connect positive (+) probe of multimeter on terminal board lower position 16. (8) Connect negative (-) probe of multimeter on ground quick-connect terminal board (above MAIN POWER switch).