TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 41 of 1632
Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CONTINUITY TEST Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CAUTION NOTE (1) Start engine (TM 9-2320-366-10-1). (2) Allow air pressure to build until FRONT BRAKEAIR and REAR BRAKE AIR pressure gages read approximately 120 PSI. (3) Shut down engine (TM 9-2320-366-10-1). (4) Disconnect connector P110 from CTIS ECU. (5) Set multimeter to ohms. (6) Connect positive (+) probe of multimeter to connector P110 socket T. (7) Connect negative (-) probe of multimeter to known good ground and note reading on multimeter. (8) If continuity is not present, go to step 21 of this fault. TM 9-2320-366-20-2 Change 2 2-947