TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 289 of 1632
Change 2 2-1165 TM 9-2320-366-20-2 (1) Disconnect connector P171 from crane power cable connector. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to crane power cable connector pin B. (4) Connect negative (-) probe of multimeter to ground quick-connect terminal block (above main power switch) and note reading on multimeter. (5) If continuity is not present, replace crane power cable (para 7-90). (6) Connect positive (+) probe of multimeter to crane power cable connector pin C. (7) Connect negative (-) probe of multimeter to junction box terminal board position 5 and note reading on multimeter. (8) If continuity is not present, replace crane power cable (para 7-90). (9) Close cover on junction box. (10) Tighten four screws on junction box. CONTINUITY TEST