TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 261 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1137 2-1137 2-1137 2-1137 2-1137 CONTINUITY TEST (1) Remove PDP cover (para 16-2). (2) Remove three screws and washers from PDP. (3) Remove three screws from PDP. (4) Lift PDP outward to gain access. (5) Disconnect terminal lugs TL158 and TL159 from start inhibit pushbutton switch. (6) Set multimeter to ohms. (7) Connect positive (+) probe of multimeter to start inhibit pushbutton switch terminal 1. (8) Connect negative (-) probe of multimeter to start inhibit pushbutton switch terminal 2. (9) Press start inhibit pushbutton switch and hold (TM 9-2320-366-10-1) and note reading on multimeter. (10) If continuity is not present, replace start inhibit pushbutton switch (para 7-19). (11) Install PDP on dashboard with three screws. (12) Install three washers and screws in PDP.