TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 245 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1121 2-1121 2-1121 2-1121 2-1121 CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect jumper wire to connector P42-1. (3) Lower cab (TM 9-2320-366-10-1). (4) Connect positive (+) probe of multimeter to connector P31-15. (5) Connect negative (-) probe of multimeter to jumper wire and note reading on multimeter. (6) If continuity is not present, repair wire 1403 (para 2-45) or replace engine control cable assembly (para 7-80). (7) Raise cab (TM 9-2320-366-10-1). (8) Remove jumper wire from connector P42. (9) Connect connector P42 to ether sensor connector. (10) Connect connector clamp on ether sensor connector. (11) Lower cab (TM 9-2320-366-10-1).