TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 235 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1111 2-1111 2-1111 2-1111 2-1111 Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING VOLTAGE TEST (1) Disconnect connector clamp from ether valve connector. (2) Disconnect ether valve connector from connector J93. (3) Disconnect connector clamp from ether sensor connector. (4) Disconnect connector P42 from ether sensor connector. (5) Install jumper wire from connector P42-1 to connector P42-2. (6) Set multimeter to volts dc. (7) Connect positive (+) probe of multimeter to connector J93-1. (8) Connect negative (-) probe of multimeter to ground. (9) Position master power switch to on (TM 9-2320-366-10-1). (10) Press ether start switch (TM 9-2320-366-10-1) and note reading on multimeter. (11) If 24 vdc is not present, go to step 3 of this fault. (12) Release ether start switch (TM 9-2320-366-10-1). (13) Position master power switch to off (TM 9-2320-366-10-1). (14) Remove jumper wire from connector P42-1 and connector P42-2. (15) Connect connector P42 to ether sensor connector. (16) Lower cab (TM 9-2320-366-10-1).