TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1093 of 1632
CAUTION CONTINUITY TEST NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. (1) Disconnect batteries (para 7-57). (2) Remove PDP cover (para 16-2). (3) Remove three screws from PDP. (4) Remove three screws and washers from PDP. (5) Lift PDP outward to gain access. (6) Set multimeter to ohms. (7) Connect positive (+) probe of multimeter to connector P116 socket 4. (8) Connect negative (-) probe of multimeter to terminal board TB1 position 60 and note reading on multimeter. (9) If continuity is not present, Repair wire 146 from connector P116 socket 4 to terminal board TB1 position 60 (para 2-45) or replace WTEC III dashboard cable assembly (para 7-11). (10) Connect connector P116 to WTEC III ECU. (11) Connect connector clamp to connector P116. (12) Install kick panel (para 16-3). TM 9-2320-366-20-2 Change 1 2-1822.25