Sign up to sell your inventory with NSN Lookup

TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download

Page 1089 of 1632

CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector PX33 socket T. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, Repair wire 186 from connector PX33 socket T to terminal board TB2 position 15 (para 2-45) or replace WTEC III dashboard cable assembly (para 7-11). TM 9-2320-366-20-2 Change 1 2-1822.21