TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1087 of 1632
WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. VOLTAGE TEST NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. (1) Connect connector P116 to WTEC III ECU. (2) Connect connector clamp to connector P116. (3) Remove instrument panel for access (para 7-15). (4) Disconnect connector PX33 from WTEC III TPSS. (5) Set multimeter to volts DC. (6) Connect positive (+) probe of multimeter to connector PX33 socket R. (7) Connect negative (-) probe of multimeter to ground. (8) Position master power switch to on (TM 9-2320-366-10-1) and note reading on multimeter. (9) Position master power switch to off (TM 9-2320-366-10-1). (10) If 24 VDC is not present, go to step 9 of this fault. TM 9-2320-366-20-2 Change 1 2-1822.19