TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1077 of 1632
CONTINUITY TEST CAUTION Use care when testing electrical connectors not to bend connector pins or damage connector sockets with multimeter probes. Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE TM 9-2320-366-20-2 Change 1 2-1822.9 (1) Connect positive (+) probe of multimeter to connector P116 socket 32. (2) Connect negative (-) probe of multimeter to connector PX33 socket P and note reading on multimeter. (3) Connect negative probe (-) of multimeter to all other sockets in connector PX33, one at a time, and note reading on multimeter. (4) Connect negative probe (-) of multimeter to ground and note reading on multimeter. (5) If continuity is not present in step 2, or continuity is present in step 3 or step 4, repair wire 143 (para 2-45) or replace WTEC III dashboard cable assembly (para 7-11). (6) Connect connector P116 to WTEC III transmission ECU. (7) Connect connector clamp on connector P116.