TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1073 of 1632
TM 9-2320-366-20-2 Change 1 2-1822.5 CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector P115 socket 17. (3) Connect negative (-) probe of multimeter to a known good ground and note reading on multimeter. (4) If continuity is not present in step (3), repair wire 143 from connector P115-17 to terminal board 2 pin 27 (para 2-45) or replace WTEC III dashboard cable assembly (para 7-11). (5) Connect positive (+) probe of multimeter to connector P115 socket 25. (6) Connect negative (-) probe of multimeter to a known good ground and note reading on multimeter. (7) If continuity is not present in step (6), repair wire 144 from connector P115-25 to chassis ground (para 2-45) or replace WTEC III dashboard cable assembly (para 7-11). (8) Connect positive (+) probe of multimeter to connector P115 socket 32. (9) Connect negative (-) probe of multimeter to a known good ground and note reading on multimeter. (10) If continuity is not present in step (9), repair wire 143 from connector P115-32 to terminal board 2 pin 16 (para 2-45) or replace WTEC III dashboard cable assembly (para 7-11). (11) Connect connector P115 to WTEC III Transmission ECU. (12) Connect connector clamp on connector P115.