TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1068 of 1632
TM 9-2320-366-20-2 2-1822 Change 1 INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Multimeter, Digital (Item 22, Appendix C) STE/ICE-R (Item 41, Appendix C) Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C) KNOWN INFO POSSIBLE PROBLEMS Faulty WTEC III dashboard cable assembly. Faulty WTEC III TPSS. Faulty WTEC III transmission ECU. 1. Does main code 23 logged in WTEC III TPSS return after clearing diagnostic code? CAUTION Read CAUTION on following page. START Circuit Breakers CB43 and CB79 OK. TEST OPTIONS WTEC III Diagnostic Code Clearing procedure. REASON FOR QUESTION Fault corrected. f39. WTEC III TRANSMISSION PUSHBUTTON SHIFT SELECTOR (TPSS) DISPLAYS MAIN CODE 23 AND ANY SUB CODE YES NO NOTE Perform electrical system troubleshooting e1. Circuit Breaker Does Not Operate on circuit breakers C43 and CB79 prior to begining this task. If WTEC III TPSS does not display any diagnostic code after clearing, an intermittent problem was detected and corrected. If diagnostic code is logged after clearing, further troubleshooting is required. Tools and Special Tools (Cont) Wrench Set, Socket (Item 51, Appendix C) Personnel Required (2) References TM 9-4910-571-12&P