TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1059 of 1632
(1) Disconnect connector clamp from connector P116. (2) Disconnect connector P116 from WTEC III transmission ECU. (3) Remove instrument panel assembly for access (para 7-15). (4) Disconnect connector PX33 from WTEC III TPSS. (5) Set multimeter to ohms. (6) Connect positive (+) probe of multimeter to connector P116-16. (7) Connect negative (-) probe of multimeter to connector PX33R and note reading on multimeter. (8) Connect negative (-) probe of multimeter to all other sockets in connector PX33, one at a time, and note reading on multimeter. (9) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (10) If continuity is not present in step 7, or continuity is present in step 8 or step 9, repair wire 136 (para 2-45) or replace WTEC III dashboard cable assembly (para 7-11). CONTINUITY TEST Change 1 2-1813 TM 9-2320-366-20-2