TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1043 of 1632
Change 1 2-1797 TM 9-2320-366-20-2 WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. PRESSURE TEST (1) Position drain pan under pressure tap. (2) Remove main pressure tap plug and preformed packing from control valve module. (3) Connect tube to boss adapter, hose, and pipe to tube adapter to main pressure tap. (4) Perform STE/ICE-R Test #50 (TM 9-4910- 571-12&P). (5) Start engine (TM 9-2320-366-10-1) and run at idle. (6) With parking brake applied, position WTEC III TPSS to R position then to N position while assistant checks reading on STE/ICE-R. (7) Shut down engine (TM 9-2320-366-10-1). (8) If main oil pressure is low, notify DS Maintenance. (9) Remove pipe to tube adapter, hose, and tube to boss adapter from main pressure tap. (10) Position preformed packing and main pressure tap plug in control valve module. (11) Tighten main pressure tap plug to 84-120 lb-in. (9-14 N·m). (12) Remove drain pan under pressure tap.