TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1019 of 1632
(10) Connect connector P114 to WTEC III transmission ECU. (11) Connect connector clamp on connector P114. (12) Install kick panel (para 16-3). (13) Connect connector P119 to connector J119. (14) Position front grille on cab with washer and screw. (15) Position two washers and screws in front grille. (16) Tighten screw to 48-60 lb-in. (5-7 N·m). (17) Tighten two screws to 24 lb-in. (3 N·m). (18) Clear diagnostic codes (para 8-5). Change 1 2-1775 TM 9-2320-366-20-2 (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector P114-9. (3) Connect negative (-) probe of multimeter to all other sockets of connector P114, one at a time, and note reading on multimeter. (4) Connect positive (+) probe of multimeter to connector P114-10. (5) Connect negative (-) probe of multimeter to all other sockets of connector P114, one at a time, and note reading on multimeter. (6) Connect positive (+) probe of multimeter to connector P114-25. (7) Connect negative (-) probe of multimeter to all other sockets of connector P114 (except P114-13), one at a time, and note reading on multimeter. (8) If continuity is present in step 3, 5, or 7, replace WTEC III cab transmission harness (para 7-138). (9) If no short circuits are found, replace WTEC III transmission ECU (para 8-7). CONTINUITY TEST