TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1015 of 1632
CONTINUITY TEST CONTINUITY TEST (1) Disconnect connector P119 from connector J119. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to connector P119R. (4) Connect negative (-) probe of multimeter to connector P73 pin C and note reading on multimeter. (5) Connect positive (+) probe of multimeter to connector P119f. (6) Connect negative (-) probe of multimeter to connector P73 pin B and note reading on multimeter. (7) Connect positive (+) probe of multimeter to connector P119Z. (8) Connect negative (-) probe of multimeter to connector P73 pin A and note reading on multimeter. (9) If continuity is not present on one or more wires, notify DS Maintenance. (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector P119R. (3) Connect negative (-) probe of multimeter to all other pins in connector P119, one at a time, and note reading on multimeter. (4) If continuity is found between pin R and any other pin, notify DS Maintenance. (5) Perform steps (2) and (3) for P119f and P119Z. (6) If continuity is found between pin f and any other pin, or between pin Z and any other pin, notify DS Maintenance. (7) Connect connector P73 to TPS connector. Change 1 2-1771 TM 9-2320-366-20-2