TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1005 of 1632
CAUTION Change 1 2-1761 TM 9-2320-366-20-2 Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. (1) Remove two screws and washers from front grille. (2) Remove screw and washer from front grille. (3) Remove front grille from cab. (4) Disconnect connector P119 from connector J119. (5) Set multimeter to ohms. (6) Connect positive (+) probe of multimeter on P119h. (7) Connect negative (-) probe of multimeter on P119j and note reading on multimeter. (8) If 2 ohms (or less) resistance is present, notify DS Maintenance. (9) If resistance is greater than 2 ohms, replace WTEC III transmission ECU (para 8-7). (10) Connect connector P119 to connector J119. (11) Position front grille on cab with washer and screw. (12) Position two washers and screws in front grille. (13) Tighten screw to 48-60 lb-in. (5-7 N·m). (14) Tighten two screws to 24 lb-in. (3 N·m). (15) Clear diagnostic codes (para 8-5). RESISTANCE TEST