TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 1003 of 1632
CAUTION CLUTCH PRESSURE TEST Change 1 2-1759 TM 9-2320-366-20-2 WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. Loose or dirty connectors may cause intermittent loss of power to transmission ECU and diagnostic codes to be logged. Ensure that all connectors are clean and tight before performing troubleshooting. Failure to comply may result in incorrect test results. Sub Code 22 11 44 66 88 99 Range VER Range VER Range VER Range VER Range VER Range VER 1st 4th 2nd 6th N1 N2/N4 Sub Code Meaning Table 2-38. Sub Code Range (10) Remove pipe to tube adapter, hose, and tube to boss adapter from C3 pressure tap. (11) Position preformed packing and C3 pressure tap plug in control valve module. (12) Tighten C3 pressure tap plug to 84-120 lb-in. (9-14 N·m). (13) Remove drain pan under C3 pressure tap plug. (14) Install front and intermediate propeller shafts (para 9-2). (1) Remove front and intermediate propeller shafts (para 9-2). (2) Position drain pan under C3 pressure tap plug. (3) Remove C3 pressure tap plug and preformed packing from control valve module. Discard preformed packing. (4) Connect tube to boss adapter, hose, and pipe to tube adapter to C3 pressure tap. (5) Perform STE/ICE-R Test # 50 (TM 9-4910- 571-12&P). (6) Start engine (TM 9-2320-366-10-1) and run at idle. (7) With parking brake applied, make shift indicated by sub code while assistant notes reading on STE/ICE-R. Refer to Table 2-38. Sub Code Range. (8) If pressure does not drop to zero in selected range indicated by code values, notify DS Maintenance. (9) Shut down engine (TM 9-2320-366-10-1).