TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 987 of 1824
VOLTAGE TEST Change 1 2-604.55 TM 9-2320-366-20-1 NOTE (1) Disconnect connector P88 from RH rear side marker light connector. (2) Set multimeter to volts DC. (3) Connect positive (+) probe of multimeter to connector P88. (4) Connect negative (-) probe of multimeter to ground. (5) Position main light switch to SER DRIVE (TM 9-2320-366-10-1) and note reading on multimeter. (6) If 12 VDC is not present, repair wire 489 from connector P88 to splice E17 (para 2-44) and go to step 6 of this fault if required or replace rear lights cable assembly (para 7-84) and go to step 1 of this fault. (7) If 12 VDC is present, repair wire 489 from connector P88 to splice E17 (para 2-45) and go to step 6 of this fault if required or replace rear lights cable assembly (para 7-84) and go to step 1 of this fault. (8) Position main light switch to OFF (TM 9-2320-366-10-1). Remove plastic cable ties as required. (9) Connect connector P88 to RH rear side marker light connector. Install plastic cable ties as required. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. WARNING