TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 975 of 1824
CONTINUITY TEST Change 1 2-604.43 TM 9-2320-366-20-1 (1) Remove nut, lockwasher, terminal lug TL19, and lockwasher from RH side marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL19. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire 3095 from terminal lug TL19 to terminal lug TL20 (para 2-45) and go to step 6 of this fault if required or replace rear lights cable assembly (para 7-84) and go to step 1 of this fault. (6) If continuity is present, replace RH side marker light (para 7-38) and go to step 5 of this fault if required. (7) Install lockwasher, terminal lug TL19, lockwasher, and nut on RH side marker light screw. (8) Connect RH side marker light connector to connector P88.