TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download

Page 969 of 1824

Change 1 2-604.37 TM 9-2320-366-20-1 CONTINUITY TEST (1) Remove nut, lockwasher, terminal lug TL20 and lockwasher from RH rear marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL20. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire 3095 from terminal lug TL20 to terminal lug TL21 (para 2-45) and go step 6 of this fault if required or replace rear lights cable assembly (para 7-84) and go to step 1 of this fault. (6) If continuity is present, repair wire 489 from splice E15 to splice E17 (para 2-45) and go to step 6 of this fault if required or replace rear lights cable assembly (para 7-84) and go to step 1 of this fault. (7) Install lockwasher, terminal lug TL20, lockwasher, and nut on RH rear marker light screw.