TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 967 of 1824
CONTINUITY TEST Change 1 2-604.35 TM 9-2320-366-20-1 (1) Remove nut, lockwasher, terminal lug TL15, and lockwasher from LH side marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL15. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire 3094 from terminal lug TL15 to terminal lug TL16 (para 2-45) and go to step 5 of this fault if required or replace rear lights cable assembly (para 7-84) and go to step 1 of this fault. (6) If continuity is present, replace LH side marker light (para 7-38) and go to step 5 of this fault if required. (7) Install lockwasher, terminal lug TL15, lockwasher, and nut on LH side marker light screw. (8) Connect LH side marker light connector to connector P85.