TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 933 of 1824
CONTINUITY TEST Change 1 2-604.1 TM 9-2320-366-20-1 Wire 3094 from Terminal Lug TL15 to Terminal Lug TL16 TL15 LH Side LH Rear TL16 Replace Marker Light (para 7-38) Wire 3094 from Terminal Lug TL31 to Terminal Lug TL30 Left Rear TL30 Replace Marker Light (para 7-38) Replace Marker Light (para 7-38) Replace Marker Light (para 7-38) TL31 TL32 Middle Rear Right Rear RH Rear TL20 Wire 3095 from Terminal Lug TL19 to Terminal Lug TL20 TL19 RH Side Table 2-12.1. M1083/M1084/M1090/M1092/M1093/M1094 Side and Rear Marker Light Terminal Lugs Marker Light Connector Wire Segment (1) Remove nut, lockwasher, terminal lug, and lockwasher from marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug (refer to Table 2-12.1. M1093/M1084/M1090/M1090/M1092/ M1093 Side and Rear Marker Light Terminal Lugs). (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire (refer to Table 2-12.1. M1093/M1084/ M1090/M1090/M1092/M1093 Side and Rear Marker Light Terminal Lugs) (para 2-45) or replace rear lights cable assembly (para 7-84). (6) If continuity is present, replace marker light (para 7-38). (7) Install lockwasher and terminal lug on marker light screw with lockwasher and nut.