TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 901 of 1824
Change 1 2-586.1 TM 9-2320-366-20-1 Terminal Lug Wire Segment Table 2-11.2. Cab Clearance and Marker Light Terminal Lugs Light RH Cab Top Marker Light RH Cab Top ID Light TL3 TL3 to splice E24 TL4 to splice E24 TL4 Middle Cab Top ID Light TL8 TL8 to splice E24 LH Cab Top ID Light TL22 TL22 to splice E24 TL27 to splice E24 TL27 LH Cab Top Marker Light CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to terminal lug (Refer to Table 2-11.2. Cab Clearance and Marker Light Terminal Lugs). (3) Connect negative (-) probe of multimeter to to ground and note reading on multimeter. (4) If continuity is not present, repair wire 3097 (para 2-45) or replace cab clearance and marker lights cable assembly (para 7-66) or M1093/M1094 cab clearance and marker lights upper cable assembly (para 7-63). (5) If continuity is present, replace marker light assembly (para 7-38). (6) Install gasket on marker light base. (7) Connect connector (Refer to Table 2-11.2. Cab Clearance and Marker Light Connectors) to marker light connector. (8) Install lockwasher, terminal lug (Refer to Table 2-11.2. Cab Clearance and Marker Light Terminal Lugs), lockwasher, and nut on back of base. (9) Install marker light base on vehicle with four screws. (10) Install marker light lamp in socket. (11) Install lens cover on base with two screws.