TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 889 of 1824
Change 1 2-580.1 TM 9-2320-366-20-1 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE VOLTAGE TEST NOTE (1) Remove four screws from RH cab marker light base. (2) Remove nut, lockwasher, terminal lug TL134, and lockwasher from RH cab marker light base. Discard lockwashers. (3) Extend base and disconnect connector P132 from marker light connector. (4) Remove gasket from RH cab marker light base. Discard gasket. (5) Set multimeter to volts DC. (6) Connect positive (+) probe of multimeter to connector P132 socket. (7) Connect negative (-) probe of multimeter to ground. (8) Position main light switch to SER DRIVE (TM 9-2320-366-10-1) and note reading on multimeter. (9) If 12 VDC is not present, go to step 13 of this fault. (10) Position main light switch to OFF (TM 9-2320-366-10-1). (11) Install gasket on RH cab marker light base. (12) Connect marker light connector to connector P132. (13) Install lockwasher, terminal lug TL134, lockwasher, and nut on back of RH cab marker light base. (14) Install RH cab marker light base on vehicle with four screws. (15) Install RH cab marker light lamp in socket. (16) Install lens cover on base with two screws. Do not let wires slip through hole into cab structure. If wires slip into cab structure, vehicle will need further disassembly to retrieve wires.