TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download

Page 88 of 1824

TM 9-2320-366-20-1 1-17. 15K SELF-RECOVERY WINCH (SRW) Figure 1-26. 15K Self-Recovery Winch (SRW) When specified, any vehicle except models M1084 and M1086 may be equipped with a 15K Self-Recovery Winch (SRW) (1, Figure 1-26) mounted on the right hand frame rail. The SRW is rated for 15,500 lbs (68,944 N) pull when the winch drum has one full layer of cable. One full layer of cable is the minimum amount of cable that may be left on the drum when using the SRW. Pulling capacity is reduced with each layer of cable that is added to the winch drum. Pulling capacity with seven full layers of cable on the winch drum is 9,090 lbs (40,432 N). For recovery operations, the SRW cable may be routed to the front on all vehicles so equipped. The SRW cable may be routed to the rear of the vehicle on models M1083, M1085, M1090, M1093, and M1094. The SRW is equipped with a fail-safe brake which is spring applied and hydraulically released. The fail-safe brake is automatically applied when hydraulic pressure falls below 270 psi (1,862 kPa). The fail-safe brake will hold the load until hydraulic pressure is restored. The winch control valve functions as a throttling valve when cable is being payed out. The winch control valve controls the flow of fluid to the winch motor. When cable is being pulled in, the winch control valve acts as a free flow check valve. The winch control valve is preset at the factory and is not to be adjusted under any circumstances. 1-34