TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 843 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-549 2-549 2-549 2-549 2-549 CONTINUITY TEST VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING (1) Remove PDP cover (para para 16-2). (2) Remove relay K8 from PDP. (3) Disconnect connector P14 (RH) or connector P20 (LH) from housing. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to PDP, terminal 87A, where relay K8 was removed. (6) Connect negative (-) probe of multimeter to connector P14 (RH) or connector P20 (LH) and note reading on multimeter. (7) If continuity is not present, go to step 8 of this fault. (8) Connect connector P14 (RH) or connector P20 (LH) to housing. (1) Set multimeter to volts dc. (2) Connect positive (+) probe of multimeter to PDP, terminal 86, where relay K8 was removed. (3) Connect negative (-) probe of multimeter to ground. (4) Position main light switch to SER DRIVE (TM 9-2320-366-10-1). (5) Position headlight high beams to on (TM 9-2320-366-10-1) and note reading on multimeter. (6) If 12 vdc is not present, go to step 6 of this fault. (7) Position main light switch to OFF (TM 9-2320-366-10-1).