TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 811 of 1824
CONTINUITY TEST NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back or not capable of making good contact. CAUTION (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector PX7 pin 13. (3) Connect negative (-) probe of multimeter to terminal lug TL157 and note reading on multimeter. (4) If continuity is not present, repair wire 1525 from terminal lug TL157 to connector PX7 pin 13 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). TM 9-2320-366-20-1 Change 1 2-521 Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment.