TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download

Page 783 of 1824

TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-495 2-495 2-495 2-495 2-495 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. VOLTAGE TEST (1) Connect lighted indicator display to connector PX7. (2) Position lighted indicator display in instrument panel assembly with four screws. (3) Tighten four screws to 6-10 lb-in. (1 N·m). (4) Connect batteries (para 7-57). (5) Remove personnel heater for access (para 18-9). (6) Disconnect connector J912 from connector P912. (7) Set multimeter to volts dc. (8) Connect positive (+) probe of multimeter to connector J912-9. (9) Connect negative (-) probe of multimeter to ground. (10) Position master power switch to on (TM 9-2320-366-10-1) and note reading on multimeter. (11) If 24 vdc is not present, repair wire 2034 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (12) Position master power switch to off (TM 9-2320-366-10-1). (13) Connect connector P912 to connector J912.