TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 781 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-493 2-493 2-493 2-493 2-493 CONTINUITY TEST (1) Loosen four captive screws in lamp mounting panel. (2) Remove lamp mounting panel from lighted indicator display housing. (3) Remove dump up indicator lamps from printed circuit board. (4) Set multimeter to ohms. (5) Check continuity through each dump up indicator lamp and note reading on multimeter. (6) If continuity is not present, replace dump up indicator lamps (para 7-16). (7) If continuity is present, replace lighted indicator display (para 7-16). (8) Install dump up indicator lamps in printed circuit board. (9) Install lamp mounting panel in lighted indicator display housing. (10) Tighten four captive screws in lamp mounting panel. (11) Connect lighted indicator display to connector PX7. (12) Position lighted indicator display in instrument panel assembly with four screws. (13) Tighten four screws to 6-10 lb-in. (1 N·m). (14) Connect batteries (para 7-57).