TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download

Page 735 of 1824

TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-447 2-447 2-447 2-447 2-447 CONTINUITY TEST (1) Disconnect batteries (para 7-57). (2) Remove PDP cover (para 16-2). (3) Remove three screws and washers from PDP. (4) Remove three screws from PDP. (5) Lift PDP outward to gain access. (6) Connect positive (+) probe of multimeter to terminal board TB1, position 41. (7) Connect negative (-) probe of multimeter to terminal board TB1, position 42 and note reading on multimeter. (8) If continuity is not present, repair wire 1580 from terminal board TB1, position 41 to terminal TB1, position 42 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (9) If continuity is present, repair wire 1580 in dashboard cable assembly (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (10) Install PDP on dashboard with three screws. (11) Install three washers and screws in PDP. (12) Install PDP cover (para 16-2). (13) Connect lighted indicator display to connector PX7. (14) Position lighted indicator display in instrument panel assembly with four screws. (15) Tighten four screws to 6-10 lb-in. (1 N·m). (16) Connect batteries (para 7-57).