TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 733 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-445 2-445 2-445 2-445 2-445 CONTINUITY TEST (1) Loosen four captive screws in lamp mounting panel. (2) Remove lamp mounting panel from lighted indicator display housing. (3) Remove right turn signal indicator lamps from printed circuit board. (4) Set multimeter to ohms. (5) Check continuity through each right turn signal indicator lamp and note reading on multimeter. (6) If continuity is not present, replace lamps (para 7-16). (7) If continuity is present, replace lighted indicator display (para 7-16). (8) Install right turn signal indicator lamps in printed circuit board. (9) Install lamp mounting panel in lighted indicator display housing. (10) Tighten four captive screws in lamp mounting panel. (11) Disconnect batteries (para 7-57). (12) Connect lighted indicator display to connector PX7. (13) Position lighted indicator display in instrument panel assembly with four screws. (14) Tighten four screws to 6-10 lb-in. (1 N·m). (15) Connect batteries (para 7-57).