TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 717 of 1824
TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 TM 9-2320-366-20-1 2-429 2-429 2-429 2-429 2-429 CONTINUITY TEST (1) Loosen four captive screws in lamp mounting panel. (2) Remove lamp mounting panel from lighted indicator display housing. (3) Remove CTIS overspeed indicator lamps from printed circuit board. (4) Set multimeter to ohms. (5) Check continuity through each CTIS overspeed indicator lamp and note reading on multimeter. (6) If continuity is not present, replace lamps (para 7-16). (7) If continuity is present, replace lighted indicator display (para 7-16). (8) Install CTIS overspeed indicator lamps in printed circuit board. (9) Install lamp mounting panel in lighted indicator display housing. (10) Tighten four captive screws in lamp mounting panel. (11) Connect lighted indicator display to connector PX7. (12) Position lighted indicator display in instrument panel assembly with four screws. (13) Tighten four screws to 6-10 lb-in. (1 N·m). (14) Connect batteries (para 7-57).