Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download

Page 695 of 1824

CONTINUITY TEST NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CAUTION Change 2 2-418.5 TM 9-2320-366-20-1 (1) Raise cab (TM 9-2320-366-10-1). (2) Disconnect connector clamp from coolant temperature light switch connector, (3) Disconnect connector P37 from coolant temperature light switch. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to coolant temperature light switch connector socket 2. (6) Connect negative (-) probe of multimeter to known good ground and note reading on multimeter. (7) If continuity is not present, go to step 3 of this fault. (8) If continuity is present, replace coolant temperature light switch (para 7-22). (9) Connect connector P37 to coolant temperature light switch. (10) Connect connector clamp to coolant temperature light switch connector. (11) Lower cab (TM 9-2320-366-10-1).