TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 691 of 1824
(1) Remove instrument panel assembly for access (para 7-15). (2) Set multimeter to ohms. (3) Disconnect connector J31 from connector P31. (4) Connect positive (+) probe of multimeter to connector PX7-12. (5) Connect negative (-) probe of multimeter to connector J31-22 and note reading on multimeter. (6) If continuity is not present, repair wire 35 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para (7-11). (7) If continuity is present, repair wire 35 (para 2-45) or replace engine control cable assembly (para 7-80). (8) Connect connector J31 to connector P31. (9) Install instrument panel assembly (para 7-15). (10) Connect lighted indicator display to connector PX7. (11) Position lighted indicator display in instrument panel assembly with four screws. (12) Tighten four screws to 6-10 lb-in. (1 N∙m). (13) Connect batteries (para 7-57). CONTINUITY TEST (1) Remove instrument panel assembly for access (para 7-15). (2) Set multimeter to ohms. (3) Disconnect connector J31 from connector P31. (4) Connect positive (+) probe of multimeter to connector J31-10. (5) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (6) If continuity is not present, repair wire 3026 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (7) If continuity is present, repair wire 3026 (para 2-45) or replace engine control cable assembly (para 7-80). (8) Connect connector J31 to connector P31. (9) Install instrument panel assembly (para 7-15). (10) Connect lighted indicator display to connector PX7. (11) Position lighted indicator display in instrument panel assembly with four screws. (12) Tighten four screws to 6-10 lb-in. (1 N∙m). (13) Connect batteries (para 7-57). CONTINUITY TEST Change 2 2-418.1 TM 9-2320-366-20-1