TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 583 of 1824
TM 9-2320-366-20-1 OPERATIONAL TEST VOLTAGE TEST WARNING Change 1 2-369 (1) Connect one end of electrical wire to terminal lug TL160. (2) Connect opposite end of electrical wire to ground. (3) Position master power switch to on (TM 9- 2320-366-10-1). (4) If audible alarm does not operate, replace audible alarm (para 7-43). (5) Position master power switch to off (TM 9- 2320-366-10-1). (1) Remove instrument panel assembly for access (para 7-15). (2) Set multimeter to volts DC. (3) Connect positive (+) probe of multimeter to terminal lug TL161. (4) Connect negative (-) probe of multimeter to ground. (5) Position master power switch to on (TM 9- 2320-366-10-1) and note reading on multimeter. (6) If 24 VDC is not present, go to step 4 of this fault. (7) Position master power switch to off (TM 9- 2320-366-10-1). Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock.