TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 545 of 1824
CAUTION NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back or not capable of making good contact. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CONTINUITY TEST (1) Loosen screw in connector J116. (2) Disconnect connector J116 from WTEC II VIM. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to WTEC II VIM connector pin H2. (5) Connect negative (-) probe of multimeter to WTEC II VIM connector pin M2 and note reading on multimeter. (6) If continuity is not present, replace WTEC II VIM (para 8-6). (7) Connect connector PX33 to WTEC II VIM. (8) Tighten screw in connector PX33. CONTINUITY TEST TM 9-2320-366-20-1 Change 1 2-351 (1) Disconnect connector J115 from WTEC II TEPSS. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to connector J116 socket B2. (4) Connect negative (-) probe of multimeter to connector J115 socket 23 and note reading on multimeter. (5) If continuity is not present, replace WTEC II cab transmission harness (par 7-137). (6) Connect positive (+) probe of multimeter to connector J116 socket B2. (7) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (8) If continuity is present, replace WTEC II cab transmission harness (para 7-137). (9) Connect connector J115 to WTEC II TEPSS. (10) Connect connector J116 to WTEC II VIM. (11) Tighten screw in connector J116.