TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 493 of 1824
Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. TM 9-2320-366-20-1 Change 1 2-322.1 (1) Connect connector PX9 to fuel gage connector. (2) Connect connector clamp on fuel gage connector. (3) Install instrument panel assembly (para 7-15). (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to connector P82 socket 2. (6) Connect negative (-) probe of multimeter to a known good ground and note reading on multimeter. (7) If continuity is not present, repair wire 3001 from connector P82 socket 2 to terminal lug TL83 (para 2-45) or replace start and charging cable assembly (para 7-132). (8) If continuity is present, replace fuel level sensor (para 4-8). (9) Connect connector P82 to fuel level sensor. (10) Connect connector clamp on fuel level sensor. CONTINUITY TEST