TM-9-2320-366-20-1 MTV Unit Maintenance Manual M1083 Series - Volume 1 Download
Page 491 of 1824
RESISTANCE TEST Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST TM 9-2320-366-20-1 Change 1 2-321 (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector PX9 pin 4. (3) Connect negative (-) probe of multimeter to a known good ground and note reading on multimeter. (4) If greater than 30 ohms is present, replace FUEL gage (para 7-14). (1) Disconnect connector clamp from fuel level sensor. (2) Disconnect connector P82 from fuel level sensor. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to connector PX9 pin 4. (5) Connect negative (-) probe of multimeter to connector P82 pin 1 and note reading on multimeter. (6) If continuity is not present, go to step 5 of this fault.